RetroSound Zuma Radio Owner's Manual download pdf (Page 5)

Zuma Owner’s Manual

• Refer fuse replacement to qualiﬁ ed service personnel. When the fuse

blows out, eliminate the cause and have it replaced with the fuse pre-

scribed for this unit by a qualiﬁ ed service technician. Incorrect replacement

of the fuse may lead to smoke, ﬁ re, and damage to the product.

• If the unit does not turn on, check the connec ons ﬁ rst. Then, check

whether the fuse in your vehicle’s fuse box is blown and check the fuse at

the unit’s wiring harness.

Observe these warnings and precau ons during installa on:

• Do not expose the unit to direct sunlight or excessive heat. Excessive heat

will raise the interior temperature of the unit, which may damage the unit.

• Do not use the product where it is exposed to water, moisture, or dust.

Exposure of the unit to water, moisture, or dust may lead to smoke, ﬁ re, or

other damage to the unit and void your warranty. Make sure that the unit

does not get wet in car washes or on rainy days.

• Refer wiring and installa on to qualiﬁ ed service personnel. Installa on of

this unit requires special skills and experience. For maximum safety, have it

installed by your dealer. Retro Manufacturing is not liable for any problems

resul ng from your own installa on of the unit. Please be sure to follow

our instruc ons carefully before a emp ng installa on.

• Follow the instruc ons to install and wire the product. Not following the

instruc ons to properly install and wire the product could damage the unit

or cause an accident or ﬁ re.

• Disconnect the lead from the nega ve (–) ba ery terminal before installa-

 on. Wiring and installa on with the nega ve (–) ba ery terminal con-

nected may cause electrical shock and injury due to a short circuit. Some

cars equipped with the electrical safety system have speciﬁ c procedures

for ba ery terminal disconnec on. FAILURE TO FOLLOW THIS PROCEDURE

MAY LEAD TO THE UNINTENDED ACTIVATION OF THE ELECTRICAL SAFETY

SYSTEM RESULTING IN DAMAGE TO THE VEHICLE AND PERSONAL INJURY

OR DEATH.

• Take care not to damage the leads. When wiring, take care not to damage

the leads. Prevent them from ge ng caught in the vehicle chassis, or

from being damaged by screws or moving parts, such as seat rails. Do not

scratch, pull, bend or twist the leads. Do not run them near heat sources or

place heavy objects on them. If leads must be routed around sharp metal

edges, protect the leads by winding them with vinyl tape or similar protec-

 on.

1 2 3 4 5 6 7 8 9 10 ... 34 35

No comments

RetroSound Zuma Radio Owner's Manual Page 5